Facehugger build and paint

o
Prints came out amazing since I switched over to simplify3D. this is .12 layer height.



Changed the original model and mixed the tail in with a egg model I had and a topographical map from somewhere to fill the hold up. too awhile to figure out a nice combination of colors as you can see in the last photo.

Sprayed it with tracker yellow spray paint and gave it a black wash. Came out heavy but I really like the effect it had.



Learned a interesting side effect if you spray wrong primers on top of each other it starts to crack but looked like a cool effect.





Finished Hugger, epoxy glued to the egg, sprayed with high gloss clear coat and dripped dragon skin casting material to give it that slimy look.
